This is a great kit to learn the basics of soldering. ClockIt is a basic alarm clock with buzzer based on the ever popular ATMega168. If you're just learning how to solder, this kit should take you 15-20 minutes. If you're a weathered pro at soldering, this is a great relaxing build that should take 5-10 minutes.

This is a great kit to learn the basics of soldering. ClockIt is a basic alarm clock with buzzer based on the ever popular ATMega168. If you're just learning how to solder, this kit should take you 15-20 minutes. If you're a weathered pro at soldering, this is a great relaxing build that should take 5-10 minutes.

No programmer required. The ATmega comes with firmware installed!

Features:

* Time (AM/PM)
* Alarm (On/Off)
* Snooze (alarm resumes after a 9 minute snooze)

Kit Includes:

* 1 x ClockIt PCB
* 1 x ATmega168 (pre-programmed)
* 1 x 4-digit display
* 1 x buzzer
* 1 x 10uF cap
* 1 x 0.1uF cap
* 2 x 22pF caps
* 1 x 10k resistor
* 1 x 16MHz crystal
* 1 x barrel jack
* 1 x mini power switch
* 3 x push button reset switches
* 2 x Screws
* 2 x Plastic Standoffs
* 1 x 5V wall wart

Open Source Hardware: We like to share. The original engineering files are available for mass hackery.

* Eagle Files (Licensed under CC v3.0 Share-Alike)
* Schematic
* Source Code
* Assembly Instructions
* Improved Source Code Forum Post