Cupcake Repair
-
Kapton Tape 6mm
Basically the best tape ever. Good up to 500F (260C). Kapton aka polyimide is a really excellent space-age material. This material is incredibly strong and has excellent heat handling characteristics. Its also radiation resistant, which is rad. We use Kapton tape for attaching the Nichrome wire to the heater barrel among other things. Its a fantastic bit of gear that everyone should have hanging around. This particular tape we sell is 1/4" x 36yds. This roll of tape is enough to do 10 or more extruders. Very handy.
$6.00 -
Acrylic Build Surface
A laser-cut and etched build surface for your CupCake CNC to make printing easy and reliable.
$12.50Out of stock -
Ceramic Insulation Tape
High temperature ceramic tape good up to 2300F. Used on the extruder as insulation.
$1.50Out of stock
-
Kapton 20 mm tape
This is Kapton 20mm tape. It's our classic Kapton tape, but 15mm WIDER than we've ever offered. It's all the great features of Kapton tape in a nice thick strip. Great for heated applications, and insulating electrical joints and heating elements. It has tons of uses and is easy to clean up when you remove it. We know MakerBot® Operators really like our regular Kapton, so this is just more of a good thing! This tape is 20mm wide, or 13/16" wide, in those pesky imperial units!
$9.25 -
MK6 Plus Safety Thermostat
Specifications: THERMOSTAT 140 DEG C NC W/LEADS Category: Circuit Protection Family: Temperature Regulators Series: F20 Circuit: Normally Closed Switching Temperature: 284°F (140°C) Package / Case: TO-220 Mounting Type: Through Hole Lead free / RoHS Compliant Datasheet available here
$8.00 -
NEMA 17 Hybrid Stepper Motor
This is a stock motor that has a 5mm diameter shaft. It's also great for all kinds of mechanical projects, robotics, and projects. It's fully compatible with the Generation 3, and Generation 4 MakerBot® Stepper Driver electronics. Pre-assembled connector that is compatible with both the Stepper Driver v2.x and v22.x boards that we sell. Plug and play! NEMA-17 is a standard motor mounting geometry. The outside of the motor housing is 1.7"x1.7". *If your CupCake CNC or Thing-O-Matic® was purchased before 5/15/2011, please email us before ordering this item to install on your Bot. You will need the Motor pulleys with 5mm bore.
$21.00Out of stock
