You have no items in your shopping cart.
Product Description
Our robots require stepper motors and we've searched the world high and low and acquired the Stepper Motor - Nema 23 - Keling KL23H51-24-08B for you to acquire and hook up.
This is the RepRap stepper motor for the Arduino controller. It has 200 steps to one revolution (1.8degree per step). It actually has 4 coils (which means it can be wired as both a bipolar and unipolar), but we join up the wires to turn it into a bipolar motor. It is much cheaper than the Nanotec, and with half-stepping it is almost as accurate.
Bipolar - Serial
This configuration is suited for our driver boards. It has higher impedance and higher ohms which means it draws less current. In this mode its ideally matched to our L298 based boards. In this wiring setup it can handle 1.5 amps, which is just right. We recommend wiring it in this configuration.
Name Color
A Blue
B Green
C Brown
D White
You will also need to splice the following wires together:
* Red and Yellow
* Black and Orange
Browse the full specifications online.
This is the RepRap stepper motor for the Arduino controller. It has 200 steps to one revolution (1.8degree per step). It actually has 4 coils (which means it can be wired as both a bipolar and unipolar), but we join up the wires to turn it into a bipolar motor. It is much cheaper than the Nanotec, and with half-stepping it is almost as accurate.
Bipolar - Serial
This configuration is suited for our driver boards. It has higher impedance and higher ohms which means it draws less current. In this mode its ideally matched to our L298 based boards. In this wiring setup it can handle 1.5 amps, which is just right. We recommend wiring it in this configuration.
Name Color
A Blue
B Green
C Brown
D White
You will also need to splice the following wires together:
* Red and Yellow
* Black and Orange
Browse the full specifications online.
Product Tags
Add Your Tags:
Use spaces to separate tags. Use single quotes (') for phrases.